Mitutoyo Lever Head Probe for Mu Checker 0.02N Force

The lever head probe plugs into a Mu checker indicator and is used to measure even soft workpieces, such as the warp of a LCD panel, due to the low measuring force used by the probe. NOTE: This is only the probe. The indicator is available for purchase separately.

A comparison of the available Mu checker probes can be found here.

The probe has the following specifications:

• Measuring range: ± 0.5mm
  
• Stylus stroke: ± 0.6mm
• Measuring force: ~0.02N
• Bearing Unit Structure: Pivot bearing type. NOTE: If the stylus makes an angle with a workpiece surface, a calibration should be performed for accurate measurement or use the correction factor table below.
• Linearity: ±0.3%
  
• Size: ~14mm W x 100mm D x 28mm H (probe only, not including cable). Cable is 2m long and has a MAS-5100 (DIN5P) attachment at one end that connects to the Mu checker indicator.
  
• Includes: Stylus with Ø2mm diameter ball-ended tip.
• Additional compatible styli may be purchased here.
  
• Mu checker indicators can be purchased here.
  

NOTE: This item is not returnable.

Mitutoyo Part # 519-522

Use the following equation to find the correct value when using the mu checker probe:

Display value x Correction factor = Corrected value

Correction factor table for Stylus Angle: